Tel
13924628001
Tel：
86-13924628001
Product Description:
1, the antenna array is composed of three layers, the top layer is 48 array antenna units, receiving electromagnetic wave signals;
2, the middle layer is the calibration network, the calibration network distributes the input reference signal to 48 dual low noise amplifiers according to the principle of constant amplitude in phase; The dual-channel low noise amplifier selects the antenna signal or the reference signal through the RF switch;
3, amplifier circuit gain is high, low noise factor, with high dynamic reception function;
4, the antenna structure has enough strength to meet the vibration requirements of the ground;
5, antenna and circuit do three protection treatment;
6, unique waterproof and dustproof design, meet the waterproof IP67, ensure that the core unit and components are completely sealed, meet the outdoor complex environment, can work normally for a long time outdoors;
7, equipped with air vent valve, to ensure that the antenna working inside and outside the pressure is stable.
Electrical Specifications
Passive antenna：
Frequency Range(MHz)：2200～2300
Gain(dBi)：≥9（Zenith gain）
VSWR：＜1.8
Polarization：Orthogonal double circular polarization
3dB Beamwidth(°) : Orientation ≥120° Pitch ≥60°
Front and back ratio(dB) : ≥15
Antenna unit isolation (dB) : ≥20
Dual low noise amplifier:
Frequency Range(MHz) : 2200 ~ 2300
LNA Gain(dB) :
35 + 2
-5 ~ 0 (low gain, maximum input 10dB linear)
Standing wave ratio VSWR: < 2
Noise Figure (dB)：＜2.5
DC Voltage (V)：3～3.3
Current (mA)：＜140
Mode control signal:
Through-core capacitance, TTL level, inverter isolation
The high level corresponds to the antenna signal, and the low level corresponds to the reference signal
Status control signal:
Through-core capacitance, TTL level, inverter isolation
High level corresponds to high gain, low level corresponds to low gain
Reverse isolation (dB) : ≥50
OP1dB（dBm）：≥10
OIP3 （dBm）：≥20
In-band flatness (dB) : ±2
Burn-out resistance (dBm) : 20dBm continuous wave
Calibration mode isolation: the antenna signal is cut off, and the insertion loss is not less than 40dB
Calibration port consistency: The amplitude difference between the calibration port and the two inputs does not exceed ±0.2dB. The phase difference between the calibration port and the two inputs does not exceed ±1 degree
Mechanical Specifications
Connector：Y50X10-1614Z10K/TNC-K
Dimensions(mm)：890×560×100.4
Weight(kg)：＜50
